Moxa Technologies EtherDevice Installationsanleitung

Moxa EtherDevice Switch EDS-G205 Hardware Installation Guide Second Edition, April 2009 © 2009 Moxa Inc. All rights reserve

- 10 -LED Indicators The front panel of the Moxa EtherDevice Switch contains several LED indicators. The function of each LED is described in the tab

- 11 -Auto-Negotiation and Speed Sensing The EDS’s RJ45 Ethernet ports independently support auto-negotiation for transmission speeds of 10 Mbps, 100

- 12 -Regulatory Approvals Safety UL508(Pending) Hazardous Location UL/cUL Class I, Division 2, Groups A, B, C, and D; ATEX Class I, Zone 2, Ex nC n

- 2 -Overview The EDS-G205 series is equipped with 5 Gigabit Ethernet ports, making it an ideal and economical solution for demanding, high bandwidth

- 3 -Panel Layout of EDS-G205 6752892211101212131134ON DIP1234521Front Panel ViewTop Panel ViewRear Panel ViewFAULT 1. G

- 4 -Mounting Dimensions (unit = mm) PWR2PWR1FAULT DIN-Rail Mounting The aluminum DIN-rail attachment plate should already be fixed to the back panel

- 5 -STEP 2: Mounting the EDS on the wall requires 4 screws. Use the switch, with wall mount plates attached, as a guide to mark the correct location

- 6 - You should also pay attention to the following items: y Use separate paths to route wiring for power and devices. If power wiring and device w

- 7 -Wiring the Redundant Power Inputs The top two contacts and the bottom two contacts of the 6-contact terminal block connector on the EDS’s top pa

- 8 -1000BaseT RJ45 Pinouts Pin MDI MDI-X1 BI_DA+ BI_DB+2 BI_DA- BI_DB-3 BI_DB+ BI_DA+4 BI_DC+ BI_DD+5 BI_DC- BI_DD-6 BI_DB- BI_DA-7 BI_DD+ B

- 9 -Alarm Contact The Moxa EtherDevice Switch has one Alarm Contact located on the top panel. For detailed instructions on how to connect the Alarm