Moxa Technologies WE-2100T Series Bedienungsanleitung Seite 4

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 50
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 3
3-3
www.m o x a . c o m e - m a i l : i n f o @ m o x a . c o m
Serial Device Servers
3
Serial Device Servers
In Pair Connection Mode, two NPort device servers are used to
transmit RS-232 signals over Ethernet, and in this way overcome
the 15-meter limitation imposed by the RS-232 standard. One
NPort connects to the PC's COM port, and the other NPort
connects to the device. Both NPorts are either connected to each
Pair Connection Mode
other by a crossover Ethernet cable, connected to the same LAN,
or connected to a WAN. Both data and modem control signals can
then be exchanged between the PC and the device over Ethernet,
but DCD signals will not be transmitted.
In Ethernet Modem mode, the serial port is connected to a PC's
COM port and behaves as if it were an attached modem. However,
the data travels directly over the network rather than over phone
Ethernet Modem Mode
lines. Ethernet Modem mode enables network access for legacy
software that was originally designed to transmit data by modem.
In Reverse Telnet mode, the serial port provides a connection to a server
and connections are initiated by a host over Ethernet. This is similar to
TCP server mode, except Reverse Telnet mode also provides Telnet-style
CR/LF conversion. Reverse Telnet mode can be used for remote console
management, where the NPort is used to enable network access to the
serial console ports of different equipment, such as routers, switches, or
servers.
Reverse Telnet Mode
Mode Selection Flow Chart
Using legacy
COM-based software?
Host requires more
COM ports?
Using MOXA's
drivers?
Real COM
Mode
RFC2217
Mode
Contact your
saleperson.
Reverse
Telnet
UDP Mode
Start
TCP Server
Mode
TCP Client
Mode
Pair
Connection
Modes
RFC2217
Mode or TCP
Server Mode
Need to extend
serial transmission
range?
Need to perform
console
management?
Host application is
server or client?
Need serial control
parameters?
Using socket
program?
Which protocol,
TCP or UDP?
YESYES
YESYES
YESYES
YESYES
YESYES
TCPTCP UDPUDP
NONO
NONO
NONO
NONO
NONO
NONO
YESYES
ClientClient
ServerServer
Seitenansicht 3
1 2 3 4 5 6 7 8 9 ... 49 50

Kommentare zu diesen Handbüchern

Keine Kommentare