Moxa Technologies Moxa Smartio C168H Installationsanleitung

A.1.1.1.1.1.1. MOXA Multiport Board Windows XP Driver Installation Guide October, 2001 Moxa Technologies Co., Ltd. Tel: +866-2-8919-1230 Fax: +886

87. When the Welcome to the Add Hardware Wizard window opens, click on Next to continue with the installation process. 8. The Windows XP operatin

99. The next window to open reads: The following hardware is already installed on your computer. Click on the Add a new hardware device option to h

1011. The next window to open reads: From the list below, select the type of hardware you are installing. Click on the Multiport serial adapters opt

11 If the company name, Moxa Technologies Inc., is not listed, or you are unable to find the correct model name for the ISA Multiport Board you are

1214. Use the folder selection tool located to the right of Look in: to find the folder in which your ISA Multiport Board’s driver files are located

1317. Click on the correct model to highlight it—for this example, we installed MOXA Smartio C168 Series (ISA Bus)—and then click on Next to continu

1419. You may safely ignore any warnings from the operating system about compatibility with Whistler. Click on Continue Anyway to proceed. 20. A se

1521. The next window verifies that the driver software for your ISA Multiport Board has been installed. Click on Finish to continue. Installing t

163. When the Found New Hardware Wizard starts up, choose the option Install the software automatically (Recommended), and then click on Next to co

175. The next window to open verifies that the software for MOXA Port 0 has been successfully installed. Click on Finish to complete the installati

Table of Contents Automatic Installation - for C218T/PCI and C32010T/PCI only... 2 Installing the C218T/PCI Multiport Board

18Multiport Board Properties Your Multiport Board’s configuration parameters are easily changed from within the Windows XP system’s device manager.

19 3. To evoke the device manager, click on System, located under the See Also options.

20 4. If your operating system is set to the older “Classic View” style, double click on the Control Panel’s System icon. 5. The Windows XP Syste

216. Select the Hardware tab, and then click on Device Manager…. 7. Click on the plus sign to the left of Multi-port serial adapters and then dou

22General Information on the General page gives basic details about the Multiport Board and its current status. Configuration Select the Propertie

232. This allows you to make changes to Port Number, UART FIFO, and Transmission Mode. Driver The Driver page displays important information a

24Resources The Resources page displays information about I/O Range, Memory Range, and IRQ. Port Configuration In this section, we describe how to

252. The MOXA Communication Port 1 (COM 12) Properties page opens. 3. Click on the Port Settings tab to view and/or make changes to Baud Rate, Da

1We explain in this manual how to configure Moxa Multiport Boards to operate under the Windows XP operating system. The installation and configurati

2Automatic Installation - for C218T/PCI and C32010T/PCI only The examples in this section where produced using MOXA Intelligent C218T/PCI, which is

35. The Windows XP operating system will take a few seconds to search for the new hardware. 6. You may safely ignore any warnings from the operat

47. Wait patiently while the appropriate files are copied to your hard drive. 8. Click on Finish to complete the installation. Moxa Intelligent

59. This completes the installation of your MOXA C218T/PCI. You should see the following message from the Windows XP operating system. Continue in

63. From the Windows XP desktop, click on Start à Control Panel. 4. [To work from “Classic View”, skip to step 6.] If your operating system is se

75. Click on Add Hardware, found under the See Also options. 6. If your operating system is set to the older “Classic view” style, double click o