Moxa Technologies NE-4100 Betriebsanweisung PDF herunterladen (Seite 21)

NE-4100 Series Serial Command Mode User’s Guide

Page 18

Chapter 8 SW Reset Function

Network Enabler Administrator provides an easy way to enable NE-4100-CMD’s software reset

function. To enable this function, open the NE’s Configuration page, .click on the Digital IO tab,

and then check the Enable SW RESET Function (Use DIO 1) checkbox.

As indicated, the RESET command will be transmitted through GPIO1.

! SW Reset Pin: GPIO 1

! Reset is executed by pulling GPIO 1 low (normal is pulling high)

a. Pull 3 sec. to erase the password.

b. Pull 10 sec. to load factory defaults.

NOTE

The SW Reset function is disabled by default. If SW Reset is enabled, then since “disable” is the

default, it will be reset to “disabled” automatically after receiving a 10 sec. SW Reset command.

This helps to prevent users from resetting to the default values inadvertently.

1 2 ... 16 17 18 19 20 21 22 23 24 25

Keine Kommentare

Moxa Technologies NE-4100 Betriebsanweisung Seite 21